For bonding rough or irregular surfaces, 3M™ Double Coated Foam Tapes fill gaps and distribute stress uniformly over the bonded area.įor industrial/occupational use only. Applications for double coated tape are found in construction, fabrication, arts, and hobby. The adhesive is protected by a peel-away liner that can be removed at the time of application or left in place until the joining surfaces are ready to be attached. In general, double coated tape is composed of a foam, paper, film, or tissue carrier that is coated on both sides with pressure sensitive adhesive. Our tapes can be easily applied by hand or with a dispenser, with no special application equipment required for a firm bond. Instead of mechanical fasteners such as screws, bolts and studs, double coated tapes leave no puncture holes. Indoor general purpose mounting and joiningģM double coated tapes offer speed, strength and improved aesthetics to your mounting application.It’s important that when using this heating method, users exercise caution while removing 3M double-sided tape from plastic surfaces or any surfaces that can degrade due to moisture exposure.3M™ Double Coated Removable Foam Tape 4658 is a great choice for general interior and exterior mounting applications Recommended Application This heating method is suitable for removing 3M double-sided tape from automotive surfaces, walls, plastic, or any other sort of surface that can tolerate moisture.īe sure not to use this method on surfaces where moisture may have repercussions. When your iron has heated up, carefully iron over the surface of the wet towel. Then, place the thin and wet towel over the tape that you wish to remove and set your iron to medium-high. First, you need to locate iron and a wet towel. Some people even say it’s more efficient to use moist heat than heat. Removing 3M double-sided tape from various surfaces isn’t difficult at all. If there is paint residue left behind, use nail polish remover to get it off. We suggest soaking a cotton ball with alcohol and then gently rubbing the cotton ball over the item in question. You want to remove 3M double-sided tape from metal, plastic, or other smooth items, but the problem is you don’t want the paint to come off. If there are still any excess remnants of 3M left behind, don’t worry as simply washing them off with a dishwashing detergent should be sufficient. Once this time frame has elapsed which should be more than enough given how thick 3M double-sided tape is use an old (and unsharpened) butter knife or credit card and gently begin peeling away the decal. Leave it for between five and ten minutes as this will give enough time for the chemical in the adhesive remover to loosen and break down the bond between your car’s finish and the sticky glue. You’ll need to apply the supplied liquid directly to the offending area where the 3M double-sided tape has been attached to.

This method, although not suitable for all surfaces, is ideal for removing 3M double-sided tape from your car without causing any body damage.įirstly, you can use a commercial adhesive remover that you can purchase online. It’s good practice to use a razor blade to carefully take off any leftover tape and residue.Īvoid scratching the paint, as this tends to be a more permanent style of damage and isn’t worth risking in most cases.

While at the same time pulling it at the same time in an upward motion with both hands, you must be careful not to grip hard so you don’t rip anything off as well. The procedures to be able to get the trim off are by making use of a hair drier, heat gun, spatula, or any other tool used for the removal process.įor the 3M adhesive system, it’s best to use a hair drier and when the tape is ready you can then begin to push in on one side with your hand. Use a Heat GunģM apply makes use of three methods in order to remove their double-sided tape.

If glue residue remains, use a solvent adhesive remover as directed by the manufacturer. Pull the taped surfaces apart carefully.Ĭarefully scrape off any remaining residue and tape sections with a razor blade. Warm the surfaces that are taped together using a heat gun or blow dryer.

3m double sided mounting tape removable